Covered almost entirely in very fine "sadeli" marquetry that is associated primarily with Gujarat.
Sheathed 31.5 cm
Dagger 31.3 cm
Base 4.5 mm
Middle 4.5 mm
Base 49 mm
Middle 43 mm
Total 580 grams
Dagger 307 grams
Anything similar for sale?
Jambiya (جنۢبية janbīyah) is the Arabic word for dagger. It is usually used to describe the specific type of dagger that is highly popular in the Arabian peninsula. The word was popularized in north India from at least the times of Akbar in the 16th century, as it is used to describe a type of dagger in the Ain-i-Akbari of circa 1590.
Indian metalworkers also produced jambiya in more Arab styles, some for export but some certainly also for use by the Arab communities within India.
Notes to introduction
1. See: Ain-i-Akbari (Persian: آئینِ اکبری) or the "Administration of Akbar", circa 1590. Several translations exist. The original manuscripts is preserved in Hazarduari Palace, India.
A fine Indian made jambiya. It has the typical wide, curved blade with a central ridge. The blade is nicely shaped, with better geometry than seen on most, but it's far from the most impressive part of this ensemble.
It comes in a beautiful gilt-copper hilt and scabbard, worked entirely in repousse work where the designs are first hammered out from the back of the plate, after which the work is reversed to work it to further detail using chisels and punches. The copper was then gilt by means of fire-gilding, where an amalgam of mercury and gold is applied to the surface, and then the mercury is evaporated with heat, leaving a relatively thick layer of gold. The achieved effect is beautiful but fell out of use due to the health hazards associated with working with mercury.
The repousse designs consist of swirling floral patterns within a border of geometric designs. The scabbard end misses the usual flower bud shaped finial, and instead is capped with a piece of fine filigree that was soldered on. The scabbard has a diagonal band at the front that is typical of Daggers from Medina that were brought back by pilgrims to Mecca, yet the workmanship on this example is entirely Indian.1
The hilt is also of more Indian form, resembling that of earlier chilanum daggers with a center ball grip and a hilt profile that flares out in both directions.
A very close comparable is in the Metropolitan museum in New York, accession number 36.25.762a, b. It has the Oldman / Stone provenance, being bequethed to the museum upon Stone's passing in 1935.
Two Indian made jambiya compared.
Left: Metropolitan Museum accession number 36.25.762a, b.
Right: The piece currently under discussion.
While the resemblance is uncanny, close inspection shows that the workmanship on our example is far superior, with the decoration on the Met's example being somewhat more simplistic in design, and superficial in execution. The Met's example has also been subject to much more wear, with more of the gold being worn off and the underlying copper showing through.
The Met's example does retain its bulb finial, and the one on ours probably once had one of much the same shape.
Another Indian made jambiya, of slightly different form but with similar style decor was published in Holstein:
Indian made Jambiya of Holstein.
And finally, a similar example, especially in terms of the hilt, was auctioned at Christies London on October 13, 1998 for £805,-.
Dating & attribution
The type of work is primarily associated with Kutch, Gujarat, by the late 19th century had spread across a wider area, possibly due to craftsmen fleeing Kutch during one a series of famines that struck the area in the 19th century.2
Holstein attributes his dagger to Hyderabad or Bijapur and suspects it was made for the Arab soldiers under a Deccan ruler.3 Writing in 2020, I think this is a bit of a stretch; The style is very much Kutch in origin and these daggers are primarily worn by Arab men as part of their daily outfit and are not very well suited as weapons of war. We don't need to venture all the way to the Deccan to find Arabs, as there were communities of Arabs living in Gujarat.
The very local style of the dagger makes me believe it was probably made for a local Arab who had an appreciation for Kutch style repousse work. The reference in its scabbard design to the pilgrim jambiyas of Medina may be a subtle reference to having completed the pilgrimage to Mecca, the duty of every Muslim.
Very good condition. Blade with minor patches of corrosion, mostly in good shape. Hilt and scabbard in near-mint condition, with more than 99% of the thick gold remaining. The only missing part is the scabbard's finial, now covered with a fine filigree cap.
A very nice example of an Indian made jambiya dagger. Some of these were made with export in mind, but this one with its strong Gujarati aesthetics was probably produced for Arabs living in India who had an appreciation for Indian design. The scabbard refers to pieces made in Medina that were often brought back by pilgrims from Mecca. The execution of the metalwork is a superb example of Kutch style repousse.
1. See: David G. Alexander; Islamic Arms and Armor in the Metropolitan Museum of Art. Yale University Press. New Haven and London. 2015. Page 226.
2. See for example a brass container with Kutch style floral repousse work made at Pune in the western Indian state of Maharashtra in: Thomas Holbein Hendley; Memorials of the Jeypore Exhibition 1883: Industrial art. Vol. I. Jaipur, India. 1883. Plate XXIV.
3. Holstein, P.; Contribution à l'Étude des Armes Orientales: Inde et Archipel Malais. Volume 2. Paris, A. Lévy, 1931. Page 45, catalog number 31, Plate XIX.
Do you have anything for sale?
I might be interested in buying it.Contact me
With markings attributing it to the Tongzhou incident and a Japanese surrender tag.
With a large double-edged tip and golden cresting.
An assortment of Indian arrows with various heads.
With less common wooden hilt and elaborately inlaid blade in brass, copper and silver.
The famous sidearm of the headhunters of Borneo.